Jolt.js is a programmable Bluetooth motor driver board. Control powerful external devices such as lights, motors, solenoids and relays, all from a device that can run for months or even years on a battery!

During November, the first 50 Jolt.js ordered will come free with two yellow 1:90 TT Motors!

This is a bundle containing a Jolt.js plus extra useful components, in a box - you can also buy Jolt.js on its own

This bundle contains:

Jolt.js and its silicone case
A 300mAh Lithium Polymer battery that can plug in and be recharged by Jolt.js when it is connected to USB, providing enough power for 6 months with Bluetooth enabled!
4x Qwiic connectors, allowing connection to the Bangle's 2x FET outputs and 12 GPIOs
A 2mm screwdriver that fits Jolt.js's terminals perfectly
An Instruction card and clear plastic box

You can be up and running in no time - plug in the battery, connect something to the screw terminals and start making things happen in the real world immediately!

With the Espruino JavaScript interpreter on its internal ARM microcontroller, software can be uploaded, debugged and modified wirelessly from any modern computer or phone, making development of embedded devices significantly easier. Jolt.js has 8 high power outputs, capable of 1A each, as well as 4 Qwiic connectors. It can even control and be controlled by other Bluetooth LE devices.

Jolt.js Features

Bluetooth Low Energy
Espruino JavaScript interpreter pre-installed
nRF52840 SoC - 64MHz ARM Cortex M4, 256kB RAM, 1MB Flash
8x high power 1A H-bridge outputs on screw terminals
4x Qwiic/Stemma connectors (2x analog capable with 500mA FET, 2x with 4x GPIO - 14 GPIO in total)
2.7v to 18v input range
Ultra low power (down to 0.008mA) when idle
LiPo battery connector with inbuilt charger
USB-C with USB Serial support
1x 3mm mounting hole
1x Button
40mm x 40mm x 12mm with protective silicone case
PCB Dimensions: 37.2mm x 36mm

Package Contents

Shipped in clear plastic box containing:

Instruction card
Jolt.js circuit board
Jolt.js Silicone case
4x Qwiic cables
300mAh Lithium Polymer battery (LP552030)
VHB tape (to stick battery)
2mm Screwdriver (for terminal block)

See a list of tutorials for Jolt.js on the main Espruino Website or have a look on the Espruino forum.

Features
Inputs	Button, 4x high voltage (18v) analog inputs
Outputs	RGB LED, 8x 1A Motor driver outputs, 2x FET outputs
GPIO (0.1")	0
GPIO (Other)	4x GPIO on rear, 12 GPIO on Qwiic Connectors, 8x 1A motor driver outputs, 2x FET outputs
Features	Bluetooth LE, Qwiic Connectors, 8x Powered Outputs, 2x FET outputs
Memory
RAM (kB)	256
Flash (kB)	1024
Processor
Clockspeed (MHz)	64